Shopping cart is empty.
Call Today!(800)876-7706    "We Ship Anywhere"
Factory Direct Ordering    Monday-Friday 8-5 Saturday 9-3 EST
Home
Home
Portfolio
Portfolio
Portfolio

Shutters - Single Or Double

Hardware

SHUTTERS – SINGLE or DOUBLE

 

Available in Hinged or SlidingDouble Tongue & Groove Shutters

COMPLETELY ASSEMBLED LUMBER WITH ALUMINUM MITER-CUT CHANNELS

CHOICE OF LUMBER FASCIAS

UNCLUTTERED & CLEAN APPEARANCE

HEAVY DUTY HARDWARE INCLUDED

STANDARD AND CUSTOM SIZES AVAILABLE

Armour Shutters are offered as a single or double panel and can be ordered hinged or sliding. A variety of fascia designs are available to match Armour Sliding Doors and Dutch Doors. The time honored Crossbuck, Vertical or Horizontal Tongue and Groove and Smoothie are among the fascias you may choose. Whether you are choosing shutters for each stall or other areas of the barn, Armour will assist with custom sizing any window opening.

Armour shutters are manufactured by applying extensive assembly techniques such as layered lumber panels,

routing, sanding, gluing, 21 step fastening,and miter-cut channel installation. Shutter panels arrive fully assembled with lumber in position.

 

You Are Here >Barn Windows & Shutters
 

Single Tongue & Groove Shutters

Product Code: defaultTGSHUTTERSSINGLE
  • $0.00

Single Tongue & Groove ShuttersSingle Tongue & Groove ShuttersSingle Tongue & Groove ShuttersSingle Tongue & Groove Shutters
Single Tongue & Groove ShuttersSingle Tongue & Groove ShuttersSingle Tongue & Groove Shutters

Single Swing Hinged or Sliding Tongue & Groove
Shutter

Sizes: 

Opening Measurements: 

Armour Gates offers a Single Swing Tongue & Groove Shutter manufactured with the best #1 grade lumber on the market. This T&G panel swings open to one side of any barn window opening of adequate size. One panel design allows for easy open and close with the slide of one bolt latch. Each shutter arrives fully assembled with lumber. Painting or staining door lumber portion is recommended. The T&G lumber is surrounded by heavy gauge, non rusting, aluminum channels and miter cut corners. Shutters arrive with unmarred lumber fascias because all wood glue and counter sunk wood placements take place in the rear of the panel. The smooth interior surface panels provide an "edge free" surface. Custom sizes are available.

When ordering shutters, you have the option of having the T&G pattern on only one side of the shutter, Armour standard shutters show the pattern only when the shutter is in the closed position, if you wish to show the pattern only when the shutter is in the open position please specify by ordering "Reverse Fascia." We offer this option at no additional cost, as a courtesy and only upon request.

  • COMPLETELY ASSEMBLED WITH HARDWARE
  • Grille sold separately
  • All edges surrounded with heavy gauge non-rusting aluminum
  • Miter-cut aluminum channel for a "finished" appearance
  • T&G fascia lumber backed with 3/4" BC Plywood
  • T&G fascia on exterior of shutter
  • Smooth surface panels on interiors of shutter
  • Bonded with glue and wood screws at back of shutters
  • Wood screws installed countersunk in critical areas for additional strength
  • Painting or staining door lumber portion is recommended.
  • 6" Zinc Plated Tee-Hinges and necessary fasteners included for lumber installation
  • Zinc-Plated Super Latches and Latch Receiver Plates Included