THE “EPITOME” OF VENTILATION & MAINTENANCE
FREE STALL COMPONENT ASSEMBLIES
The stall component assemblies shown in these photos feature ALL
of Armour’s latest innovations. The Coolbreeze sliding stall
door with Fold Down Panel, Coolbreeze Stall Front Wall & Divider
Panels and Aluminum Dividing Top Grille feature three inch between
bar tops and one inch between bar bottoms. Armour’s very
own full length rectangular tubing of 1/8” wall thickness
Aluminum Headers and Vertical Posts are also shown.
The unique Spring Loaded Fold Down release panel
was added to each sliding stall door to allow full open-top styling.
Horses may comfortably view the aisle or be retained instantly
with this quick release panel. Panels can be assembled and installed
into any standard bar top sliding stall door.
For the lower stall front panels Armour incorporates the close-ratio
one inch between bar multi picket design which is known as Coolbreeze.
These panels adjacent to each stall door continue the unbroken
appearance using close ratio spacing and a center channel for additional
strength throughout the lower stall wall area. The divider walls
are manufactured using the same technique, as one can see, continuity
of the bar spacing is centered and consistent.
The upper stall front and divider grilles are the same length
and feature standard three inch between vertical bar spacing. Interlocking
channels allow a tight fit between the upper and lower stall panels.
Armour will manufacture the length necessary to accommodate your
facility. Stall front top panels feature built-in Feeder Access
Doors for easy access to food and water without entering or opening
the stall door.
This unique Coolbreeze styling allows full view of each stalls’ occupant,
while maximizing airflow properties.
