lift out panel
horse stall feeder access
lift feed door
Cut out feed door

Stall Front Grilles are placed in the stall front between the stall door and end post or the end wall and they fit vertically below the stall header and above the stall front wall. If you are looking for stall grilles for between two stalls, please check out our Stall Dividing/Partition Grilles tab above. If you are looking for grilles to place in a stall window opening, please check out the Stall Window Grilles information tab above.

 

Stall grilles are assembled using 1" diameter round vertical bars with 3", 2" or 1" between bar spacing (choose when ordering) and arrive welded as one (8'0" length or less) or two pieces (when you order 8'0-1/8" length grills or larger). Predrilled fastener holes are provided for quick and easy installation on the top and bottom horizontal portion of the grille which is constructed using angle or channel material. See Understanding L Series Grilles vs. C Series Grilles below for more details.  Most Stall Front Grilles have a Feeder Access Option in which Armour offers four to choose from: Our standard Feeder Access Door, which is a section of the stall bars that opens up and allows you to throw your feed through and into the stall occupant's feeder. Feeders can be mounted on the lower stall wall below the Feeder Access Door and feeders can be ordered here. A Lift Out Panel is a section of grille that is the full height ordered x 24" wide that can be completely removed from the grille. The 11" x 11" Feed Cut Out is a hole that allows feed scoop or hands to enter stall. And the EZ-Lift is also an 11" x 11" opening with a retractable door that lifts to open.

 

Understanding L Series Grilles vs. C Series Grilles:

 

L Series Stall Grilles attach to 1-1/2" lumber at the top and bottom horizontal area of the grille. The opening measurement to install this grill needs to be 4'0" high (or tall) by whatever length you choose. Fasteners are provided for installation.

 

C Series Stall Grilles attach to any surface of 1-3/4" wide or wider. C Series grilles are traditionally used for concrete block openings or lumber openings that have a sill greater than 1-3/4". The component is fastened to your 1-3/4" or wider surface at the top and bottom horizontal area of the grille. The opening measurement to install this grille needs to be 4'0-1/8" high (or tall) by whatever length (plus 1/8 of an inch) you choose. Fasteners are NOT provided with C Series Grilles.